User Manual

Putting into Operation
R&S
®
RT-ZS10E/10/20/30
19User Manual 1410.3531.02 ─ 07
Figure 2-2: Offset compensation voltage and dynamic range
There are several ways to set the offset compensation:
●
Use the vertical knob at the oscilloscope if its function is set to offset.
●
Enter the offset value in the channel settings or probe settings on the
R&S RTx.
●
Use the micro button to measure input signals with different DC offsets: assign
"Set offset to mean" to the micro button. See also Chapter 2.3.2, "Micro But-
ton", on page 18.
For more details, see the oscilloscope's user manual.
2.3.4 R&S ProbeMeter
The R&S ProbeMeter is an integrated voltmeter that measures DC voltages with
higher precision compared to the oscilloscope's DC accuracy. The DC measure-
ment is performed continuously and in parallel to the time domain measurement
of the oscilloscope.
High-precision measurements are achieved through immediate digitization of the
measured DC voltage at the probe tip.
Using the Probe