R&S®RTH1002 R&S®RTH1004 Scope Rider Specifications Data Sheet | Version 12.01 year RTH_dat-sw_en_3607-0517-22_v1201_Cover.indd 1 05.01.
Version 12.01, January 2017 CONTENTS Definitions ....................................................................................................................................................................... 3 Base unit .......................................................................................................................................................................... 4 Vertical system .............................................................................................
Version 12.01, January 2017 Definitions General Product data applies under the following conditions: Three hours storage at ambient temperature followed by 30 minutes warm-up operation Specified environmental conditions met Recommended calibration interval adhered to All internal automatic adjustments performed, if applicable Specifications with limits Represent warranted product performance by means of a range of values for the specified parameter.
Version 12.
Version 12.01, January 2017 DC measurement accuracy Channel-to-channel isolation (each channel at same input sensitivity) after adequate suppression of measurement noise by using highresolution sampling mode or waveform averaging or a combination of both input frequency < analog bandwidth ±( DC gain accuracy × |reading – net offset| + offset accuracy ) > 40 dB (meas.
Version 12.
Version 12.
Version 12.
Version 12.
Version 12.
Version 12.01, January 2017 General data Display Type Resolution Temperature Temperature loading 7.
Version 12.01, January 2017 Safety in line with IEC/EN/DIN EN 61010-1, IEC/EN/DIN EN 61010-2-030, UL/CSA 61010-1, UL/CSA 61010-2-030, IEC/EN/DIN EN 61010-2-033 (R&S®RTH1002), UL/CSA 61010-2-033 (R&S®RTH1002) Battery/power supply Battery data operating time charging time Power adapter capacity voltage input output lithium-ion rechargeable smart battery approx. 4 h approx. 4 h while instrument is switched off 72 Wh 11.25 V 100 V to 240 V at 50 Hz to 60 Hz, 1.5 A +15 V DC, 4.
Version 12.
Version 12.01, January 2017 Options R&S®RTH-B1 Mixed signal option, additional 8 logic channels Vertical system Input channels Input impedance Maximum input frequency Maximum input voltage Minimum input voltage swing Threshold groups Threshold level signal with minimum input voltage swing and hysteresis setting: normal range predefined Threshold accuracy Comparator hysteresis 8 logic channels (from D0 to D7) 100 kΩ ± 2 % || ~4 pF (meas.) at probe tips 250 MHz (meas.
Version 12.
Version 12.
Version 12.01, January 2017 R&S®RTH-K2 UART/RS-232/RS-422/RS-485 serial triggering and decoding Protocol configuration bit rate signal polarity number of bits bit order parity stop bits end of packet auto threshold setup Trigger source trigger event setup data setup Decode source display type color coding data format 300 bps to 20 Mbps idle low, idle high 5 bit to 9 bit LSB first, MSB first odd, even, none 1, 1.
Version 12.
Version 12.01, January 2017 R&S®RTH-K15 History and segmented memory Memory segmentation function maximum record length per channel (analog channels in sample acquisition mode) total memory per channel maximum record length per channel (analog channels in high resolution, peak detect, envelope and average acquisition modes) History mode total memory per channel function timestamp resolution time format history player Provides an adjustable number of memory segments for the acquisition.
Version 12.
Version 12.01, January 2017 R&S®RTH-K200 Wireless LAN Interface wireless LAN 802.11 b/g/n 2x2, 2.
Version 12.01, January 2017 Ordering information Designation Type Order No. Base unit (including standard accessories: one 500 MHz, 10:1, 600 V CAT IV voltage probe for each oscilloscope input channel; one 600 V CAT IV test lead per meter input; 4 Gbyte microSD card (installed in the instrument), compact manual; lithium-ion battery pack; power supply with plugs for EU, CH, UK, US, CAN, China, Australia) Handheld Digital Oscilloscope, 60 MHz, 2 channels, DMM R&S®RTH1002 1317.
Version 12.01, January 2017 Designation Accessories Soft Carrying Bag Ethernet Cable, length: 2 m, crossover USB Cable, length: 1.8 m, standard/mini USB connector Hard Shell Protective Carrying Case Car Adapter Battery Charger for Lithium-Ion Battery Replacement Battery Spare Power Supply, for R&S®RTH incl.
Service that adds value Worldwide Local and personalized ❙ Customized and flexible ❙ Uncompromising quality ❙ Long-term dependability ❙ ❙ About Rohde & Schwarz The Rohde & Schwarz electronics group offers innovative solutions in the following business fields: test and measurement, broadcast and media, secure communications, cybersecurity, monitoring and network testing.
