User Manual

Operating the Instrument
R&S
®
RTH
34Getting Started 1326.1561.02 ─ 03
Key Short press Long press
Open or close the "Mode", "File" or "Setup" dialog, respectively.
Outputs measurement documentation: saves
a screenshot, waveform data, results, logger
record, instrument settings, and/or text com-
ment. You can select the data for output.
Opens or closes the "Screen-
shot" dialog to configure the
documentation output.
All R&S RTH:
Only
R&S RTH1004:
The effect depends on the channel state:
If the channel is off, the key switches the
channel on and sets the focus. The key lights
up.
If the channel is on but not in focus, the key
sets the focus. The key lights up.
If the channel has the focus, the key
switches the channel off.
Open or close the "Vertical"
dialog for the correspondent
channel to configure the
channel settings.
Only
R&S RTH1002:
DMM starts or stops the meter measure-
ments (same as MODE = "Meter").
DMM REL enables or disables relative meter
measurements.
Opens or closes the "Meter"
dialog to configure the mea-
surements.
TIME and POS adjust the horizontal time scale and position of the trigger
point.
RANGE and POS set the vertical scale (vertical sensitivity) and the vertical
position of the focused waveform (analog or channel, math or reference
waveform).
SIGNAL OFF switches the focused wave-
form off.
RUN STOP starts and stops the acquisition.
Accessing the Functionality