Setup Manual
Table Of Contents
- R&S®Tx9 Transmitter System
- Contents
- 1 Information about this Manual
- 3 Introduction to Operation
- 4 Device View Description
- 4.1 System Overview
- 4.2 Transmitter
- 4.3 Exciter DVB-T2
- 4.6 Exciter ATSC
- 4.7 Exciter DTMB
- 4.11 Switchless Combiner
- 4.12 Cooling System
- 5 Task View Description
- 6 Operating the Device Manager
- 7 User Administration
Task View Description
R&S
®
Tx9
230Operating Manual 2109.9110.02 ─ 07
Fig. 5-1: SNMP menu
The XX9 transmitter family supports the versions SNMPv1 and SNMPv2c. Alarms can
be sent as v1Traps, v2Traps or v2Informs. Several destinations for error messages
(trapsinks) and several communities can be set with read only authorization and read/
write authorization. SNMP is a protocol for remote control and is offered only at the
remote Ethernet interface (X2 – 1000 BaseT). The system or transmitter has to be set
to remote to execute SET commands.
5.3.1.3 Settings on Manager End
The basic SNMP settings (port, community) on the manager end and transmitter end
have must match. You typically define these settings for each IP address in your pro-
gram (e.g. MIB browser). The SNMP version is also set in the manager; the transmitter
then detects this automatically. Subsequently, SNMP communications should already
be functioning at a basic level.
System Control