Setup Manual
Table Of Contents
- R&S®Tx9 Transmitter System
- Contents
- 1 Information about this Manual
- 3 Introduction to Operation
- 4 Device View Description
- 4.1 System Overview
- 4.2 Transmitter
- 4.3 Exciter DVB-T2
- 4.6 Exciter ATSC
- 4.7 Exciter DTMB
- 4.11 Switchless Combiner
- 4.12 Cooling System
- 5 Task View Description
- 6 Operating the Device Manager
- 7 User Administration
Task View Description
R&S
®
Tx9
234Operating Manual 2109.9110.02 ─ 07
For N+1 systems this also means that unavailable parameters may receive the
response NoSuchName, e.g. parameters from the transmitter A8 if only a 4+1 system
is present.
Fig. 5-4: Groups display
5.3.1.6 Setting Alarms
Parameters that allow configuration of the transmitter alarms can be found under the
OID "commonSnmpConfiguration". For example, it is possible to switch off the IRT
alarms (factory default setting: on) and to switch on Rohde & Schwarz alarms (factory
default setting: off). The transmitter-specific alarms offer an extensive range of configu-
ration possibilities. In addition, it is also possible to assign a user-selectable priority
and to check the current status. Since the Rohde & Schwarz MIBs contain a large
number of alarms, three predefined groups for faults, warnings and information exist, to
System Control