Setup Manual
Table Of Contents
- R&S®Tx9 Transmitter System
- Contents
- 1 Information about this Manual
- 3 Introduction to Operation
- 4 Device View Description
- 4.1 System Overview
- 4.2 Transmitter
- 4.3 Exciter DVB-T2
- 4.6 Exciter ATSC
- 4.7 Exciter DTMB
- 4.11 Switchless Combiner
- 4.12 Cooling System
- 5 Task View Description
- 6 Operating the Device Manager
- 7 User Administration
Device View Description
R&S
®
Tx9
63Operating Manual 2109.9110.02 ─ 07
Name Description Value range Access right
Power A Indicates the measured voltage of the RF detector in transistor block A. 0 V to 8 V Read only
Power B Indicates the measured voltage of the RF detector in transistor block B. 0 V to 8 V Read only
Power V Ref Indicates the nominal value which is predefined by the R&S TCE900
for internal regulation of the output power.
0 V to 6 V Read only
Power Out Indicates the measured voltage of the RF detector at the output of the
amplifier.
0 V to 8 V Read only
Reflected Out Indicates the measured voltage of the RF detector for reflected power
at the output of the amplifier.
0 V to 8 V Read only
R&S PMU901: "RF Levels" parameters
●
Path: "Device View (Home)" > "Tx <n>" > "Output Stage" > "Amplifiers" > "Ampli-
fier <n>" > Tab "RF Levels"
Name Beschreibung Wertebereich Zugriffsrecht
Power V Ref Zeigt den Sollwert an, der durch die R&S TCE900 für die interne Rege-
lung der Ausgangsleistung vorgegeben wird.
0 V bis 6 V Read Only
Power Out Zeigt die gemessene Spannung des RF-Detektors am Ausgang des
Verstärkers an.
0 V bis 8 V Read Only
Reflected Out Zeigt die gemessene Spannung des RF-Detektors für die Rücklaufleis-
tung am Ausgang des Verstärkers an.
0 V bis 8 V Read Only
R&S PHR901 (VHF, Band II): "RF Levels" parameters
●
Pfad: "Device View (Home)" > "Tx <n>" > "Output Stage" > "Amplifiers" > "Ampli-
fier <n>" > Tab "RF Levels"
Name Description Value range Access right
Power In Shows the measured power at the amplifier input. 0.000 W to
0.101 W
Read only
Power Driver Shows the measured power at the amplifier driver stage. 0.0 W to 126.0 W Read only
Power A Indicates the measured power of the RF detector in transistor block A. 0.00 W to
10334.00 W
Read only
Power B Indicates the measured power of the RF detector in transistor block B. 0.00 W to
10334.00 W
Read only
Power V Ref Indicates the nominal value which is predefined by the R&S TCE900
for internal regulation of the output power.
0 % to 100.00 % Read only
Power Out Shows the measured power of the RF detector at the output of the
amplifier.
0.00 W to
7500.00 W
Read only
Reflected Out Shows the measured power of the RF detector for the reflected power
at the output of the amplifier.
0.00 W to
1500.00 W
Read only
Transmitter