Dimensions Guide

12
13
www.rohlhome.com
Installation Instructions
Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.
MAINTENANCE
Remove the cartridge nut with a smooth jawed wrench.
Remove the cartridge.
• Clean the cavity and remove all debris.
• Liberally grease the cavity.
• Install the cartridge as shown with the ports in the right alignment.
• Install the nut
-Correct torque on the nut is 16 ± Newton (NM)
-If no gauge is available
- Hand tighten the nut
- Tighten a 1/4 turn or until snug
- Do not over tighten
• With the dome and lever off, turn on the water and test for leaks
• Then install the lever and dome and test the diverter by using the hand spray
Please note:
If there is a 99% divert or small trickle of water out the spout when using the hand
spray that is acceptable. Due to water conditions, a 100% diverting action is not always possible.