Installation Sheet

Care and Maintenance: After use, wipe down with a soft, dry cloth.

For all chrome plated surfaces we recommend cleaning this product with warm soapy water

and then dry with a dry soft cloth.

Nickel plated, satin and Inca brass finishes should be cleaned with a soft cloth and warm

water and then dried with a dry soft cloth.

Do not use cream cleaners or cleaning agents containing a corrosive acid or scouring agent

including, Softscrub, Comet, Ajax and Bonami, as these may damage the surface of the fau-

cet.

Do not use any spray cleaners with ammonia or alcohol like Windex, 409 or Fantastik.

Any use of unsuitable cleaning agents causing damage to the surface will not be covered by

the warranty.

WARRANTY: Warranty is limited lifetime. See ROHL website for details

(www.rohlhome.com)

A basic in-line filter system is required for the house to protect any debris from entering the

water supply line to the house. (i.e. due to construction or service work on the street

water main.)

ROHL LLC 3 Parker, Irvine, CA 92618

714-557-1933 www.rohlhome.com

18 INCH TOWEL BAR

CA1/18APC, CA1/18PN, CA1/18STN

#41935 07/14

Please leave instructions with the home owner once installed.

24 INCH TOWEL BAR

CA1/24APC, CA1/24PN, CA1/24STN

ROHL CASWELL ACCESSORIES

INSTALLATION INSTRUCTIONS

PAGE 1
Care and Maintenance: After use, wipe down with a soft, dry cloth. For all chrome plated surfaces we recommend cleaning this product with warm soapy water and then dry with a dry soft cloth. Nickel plated, satin and Inca brass finishes should be cleaned with a soft cloth and warm water and then dried with a dry soft cloth. Do not use cream cleaners or cleaning agents containing a corrosive acid or scouring agent including, Softscrub, Comet, Ajax and Bonami, as these may damage the surface of the faucet.
PAGE 2
18 INCH TOWEL BAR 18 Inch Towel Bar Installation Instructions 1. Mark out required positions for the 2 steel mounting pillars #2 at 18 1/8 inch centres. a. Note: The steel mounting pillars must be level. 2. Install the 2 steel mounting plates #2 to wall using the self tapping screws #3. a. Anchor sleeves #1 are provided for masonry walls. b. Drill pilot holes if required. 3. Install the towel bar and tighten the grub screws #5 as shown. s 24 INCH TOWEL BAR 24 Inch Towel Bar Installation Instructions 1.