Specification Sheet
3
Installation Instructions
w
ww.rohlhome.com
Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.
Installation Instructions
Thank you for your continuing support of the Trilfow product.
The Triflow Collection
Filter Replacement Guide
1
2
To Winterize the Unit
If you plan to be away from home for extended periods, or the filter housing maybe subject to the risk of
freezing, carry out the procedures 1-2 as above. When the risk of freezing has subsided or you wish to use the
system again open the main supply and allow the water to run for 2 minutes to flush the system, the system is
now ready to use. Freezing will invalidate the warranty.
Shut off mains supply.
A stop valve was
supplied with the
system for this
purpose, and will
be located on the
adjacent pipe work.
Turn the filtered
lever on the faucet
to the on position.
This will confirm
the water supply is
off, and release the
pressure in the
system.
5 :
Lift the filter unit
from its retaining
bracket.
6
7
8
9
Take the new cartridge
and wet the two 'O' seals
on the threaded end of the
cartridge.
Screw
carefully into
the female
thread on
the inside
of the cap.
Fit the
housing
back over
the cartridge
with a quarter
turn.
Please Note:
The cartridge is
fragile and can
be easily
damaged
if not handled
carefully. Care
should
therefore be
taken when
screwing the
cartridge into
the housing
cap.
Be careful not to
cross thread or
over tighten the
cartridge.
Replace the unit on the bracket, and
(if removed) tighten the hoses onto the
cap.
Turn on the main supply valve.
Run the filtered water for 2 minutes to
flush the system, and carefully check
the system for leaks. The system is
now ready for use.
Holding the cap clip
down rotate the
housing a quarter
turn and slide the
housing down.
4
Slide the
housing off
the filter cartridge.
Whilst holding
the cap firmly
unscrew the
cartridge. Discard
the cartridge with
your house-hold
waste, wrapped
in news paper or
placed in a
polythene bag.
Wash the housing in warm soapy
water, then rinse well.
If space is
restricted
slide the
housing
down and
then unscrew
the cartridge,
then remove
both the
cartridge and
the housing
together.
Conveniently
position a suitable
receptacle to
catch the
residual water
from the housing
and remove
hoses.
Only if necessary due to restricted access.
IMPORTANT INFORMATION
The following instructions are for the filter replacement you are installing.
Please read carefully to ensure correct installation.
In addition to the guide below it is essential that the written information overleaf is
carefully read and understood.
IMPORTANT NOTE
Do not use with water, that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system.
With a rated service capacity of 3406 litres (900 gallons) the U.1802 filter cartridge should be replaced every
six months to ensure optimum performance.
Preparation for Installer
Flush the plumbing system before installing
the Kitchen product.
Ensure you have the correct fittings to connect to
the filter faucet.
2
3
Only if fitted
with clip, as on
early models.