Owner's Manual
Table Of Contents
- Owners Manual
- Introduction
- Unpacking
- Directives
- AC Mains Supply
- Maintenance
- Location
- Streaming Amplifier Front Controls
- Streaming Amplifier Rear Connections
- Integrated Amplifier Front Controls
- Integrated Amplifier Rear Connections
- Remote Control
- USB Wi-Fi Dongle
- Connecting to the Wi-Fi
- Connections
- BluOS Playback
- MaestroUnite App
- Operation
- MQA
- Updates
- Warranty
- Troubleshooting
- Specifications
- Quick Start Guide
- Important Safety Instructions
Options Menu
The Settings Menu button on the remote brings up some customisation options for the Streaming/
Integrated Amplier, these are:
• 12v Trigger
• Wired IR
• Standby Plus
• Auto Standby
• Headphone Sensitivity
• A1 Sensitivity
• A2 Sensitivity
• MM Sensitivity
• Balance
• AV Bypass
• MAC Addresses
• Firmware Versions
• BluOS Version & IP Address (Streamer only)
Some features can also be accessed via the Maestro Unit App.
Once in the Settings Menu, use the previous and next track buttons to scroll through the options and the
Play/ Pause button to toggle the features on and off. Except for AV Bypass, where you will need to hold
down the Mute button
12v Trigger
If using the 12v Trigger feature to turn the Streaming/ Integrated Amplier on and off, you must rst enable
it here (or within the MaestroUnite app). It is toggled on and off by pressing the Play/ Pause button on the
remote or via MaestroUnite. It can only be turned on or off.
NOTE: Music Sense on A2 will not work when the 12v Trigger is turned on.
NOTE: 12v trigger will take precedent over the Auto-Standby setting. e.g. 12v trigger ON & 12V trigger
input is high the auto-standby timer is disabled
Wired IR
If using an externally wired IR receiver with the Streaming/ Integrated Amplier, this must be turned on
here (or within the MaestroUnite App) which will disable the built in IR receiver. It is toggled on and off by
pressing the Play/ Pause button on the remote or via MaestroUnite.
Standby Plus
This feature enables a variety of features.
• MaestroUnite Systems to turn on from standby and share status while in standby
• A2 automatic Music Sense (only if 12V trigger is OFF)
• BluOS visible on the network and wake from standby
With the feature turned on, the Streaming/ Integrated Amplier will consume a little more power (see
specications) but is in a ready state to be able to be woken from standby by the MaestroUnite app, music
sense or BluOS apps.
When Standby Plus is off, the BLE communication with the MaestroUnite App and the other units in the
system will not work.
It is toggled on and off by pressing the Play/ Pause button on the remote or via MaestroUnite.
roksan.com10