Owner's Manual
Table Of Contents
- Owners Manual
- Introduction
- Unpacking
- Directives
- AC Mains Supply
- Maintenance
- Location
- Streaming Amplifier Front Controls
- Streaming Amplifier Rear Connections
- Integrated Amplifier Front Controls
- Integrated Amplifier Rear Connections
- Remote Control
- USB Wi-Fi Dongle
- Connecting to the Wi-Fi
- Connections
- BluOS Playback
- MaestroUnite App
- Operation
- MQA
- Updates
- Warranty
- Troubleshooting
- Specifications
- Quick Start Guide
- Important Safety Instructions
AV Bypass
WARNING: If you are going to enable AV Bypass for A2, please ensure all ampliers are turned off at
the mains before connecting any signal cables between the ampliers.
WARNING: Ensure the volume of the AV receiver is set to minimum when rst setting this feature up
or will risk damaging your ampliers, speakers and potentially hearing.
When using the Streaming/ Integrated Amplier as part of a home cinema system with an AV receiver, the
A2 input can be used to drive 2 channels with the AV receiver driving the rest. Here, the AV Bypass mode
will need to be turned on and the appropriate RCA outputs from the AV Receiver will need to be connected
to A2. When in use, A2 should be the selected input and will have the Mute icon next to it. The three further
most right Volume Display bars will also be fully illuminated.
It is also recommended to turn on and use the 12v Trigger when using this feature. If your receiver only has
one 12v Trigger output and you still want to trigger your subwoofer, use the output on the amplier to link
round to the subwoofer.
To enable AV Bypass mode (when it is selected within the menu), hold down the mute button on the remote
to activate it. It is the same to deactivate it.
NOTE: The headphone jack will be disabled when in AV Bypass mode for A2 input If you plug in a
headphone jack whilst in AV Bypass mode, the loudspeaker outputs, line output & the headphone
output will mute. Nothing will change on the screen or volume bar.
NOTE: For AV bypass to be fully enabled, you will need to cycle out of A2 into another input and then
back again. The display will then appear as it is above and the gain of the amplier set to
maximum.
MAC Addresses
Here you will nd the MAC addresses for the Wi-Fi and bluetooth modules.
Firmware Versions
Here the rmware versions for the Streaming/ Integrated Amplier and the CD Servo.
BluOS Version & IP Address
This is on the Streaming AMplier only and is where you will nd the version of BluOS rmware and also the
IP address of the BluOS unit assigned by your router.
NOTE: Firmware versions and MAC addresses are for illustrative purposes only.
13Attessa Streaming/ Integrated Amplier