Owner's Manual
Table Of Contents
- Owners Manual
- Introduction
- Unpacking
- Directives
- AC Mains Supply
- Maintenance
- Location
- Streaming Amplifier Front Controls
- Streaming Amplifier Rear Connections
- Integrated Amplifier Front Controls
- Integrated Amplifier Rear Connections
- Remote Control
- USB Wi-Fi Dongle
- Connecting to the Wi-Fi
- Connections
- BluOS Playback
- MaestroUnite App
- Operation
- MQA
- Updates
- Warranty
- Troubleshooting
- Specifications
- Quick Start Guide
- Important Safety Instructions
USB Wi-Fi Dongle
Streaming Amplier Only
With the Streaming Amplier we include a Wi-Fi dongle and small extension cable. To be able to stream
music via BluOS, the Streaming Amplier will need to be connected to your network, whether it is by the LAN
Input or by Wi-Fi.
To connect the Streaming Amplier to your Wi-Fi network, you will need to plug the dongle into the back
of the amplier. If reception is a bit weak or the Streaming Amplier is in a cabinet, we would recommend
using the provided extension cable.
Connecting to the Wi-Fi
Streaming Amplier
There are two Wi-Fi modules inside the Attessa Streaming Amplier. One is for BluOS, the other is for the
Over The Air (OTA) updates. They should be congured at the same time using the MaestroUnite app
as documented on Page 7. However, should you run into any issues and the BluOS module needs to be
connected separately, please refer to the troubleshooting section later in this manual.
To set up for the OTA updates, you will need to download the MaestroUnite app from your app store. Once
downloaded, follow the instructions to create a system and add the Streaming Amplier to your Wi-Fi
network.
Integrated Amplier
The Integrated Amplier only has the Wi-Fi module for OTA updates. This is congured via the MaestroUnite
app and cannot be used for streaming audio, it is only for OTA updates.
Connections
Loudspeakers
Connect the loudspeakers to the terminals on the Streaming/ Integrated Amplier.
Banana plugs can be used, but the red and black plastic caps need to be removed rst.
Once removed, insert the banana plug directly in to the terminal. Alternatively bare wire
can also be used by unscrewing the terminal and placing the cable through the through
hole in the terminal and clamping it rmly in place.
Speaker Connection Polarity
Carefully observe polarity ensuring that the red (+) speaker terminal/ cable is
connected to the red (+) amplier terminal and the black (-) speaker terminal/ cable to
the black (-) amplier terminal.
When both left and right loudspeaker outputs are connected to their respective loudspeakers the amplier
is ready for use.
IMPORTANT: Please ensure the unit is disconnected from the mains power supply before
connecting the loudspeaker cables.
NOTE: Litz-wound loudspeaker cables or those with a complex plaited construction can present a
highly capacitive load to an amplier and may cause damage to the amplier and/ or degrade the
sound of your system. Choose a cable of simple construction, manufactured from high-quality
materials. Your ROKSAN retailer will be able to advise.
NOTE: If using bare wire, DO NOT use speaker cable with conductor size less than 16 AWG (1.6 mm
diameter) or greater than 12 AWG (2.05 mm diameter).
NOTE: We strongly recommend that you use professionally terminated speaker cables using 4mm
plugs. Any attempt to connect cables which are not terminated may result in damage to the
amplier if not done correctly.
5Attessa Streaming/ Integrated Amplier