Owner's Manual

Signal
Connect the appropriate cables for your signal sources. If you have purchased the Attessa CD Transport as
well, it is supplied with a coaxial digital cable. This can be connected directly to the D1 input.
When partnered with the matching Attessa Turntable, set turntable output switch to PASSIVE and connect to
the Phono input, always use the supplied RCA cable as it is carefully matched to the response of the DANA
cartridge when in passive mode.
If you are using another turntable without a built in phono stage, connect this to the analogue phono
input and also connect the ground wire from the turntable to the grounding terminal on the back of the
Streaming/ Amplier. If it has a built in phono stage, then connect it to either A1 or A2 input.
The Attessa Turntable does not require a grounding cable.
LAN/ Ethernet
(Streaming Amplier Only)
For optimum network connectivity, Roksan recommend using a wired network connection. A network
connection is needed for BluOS.
USB
(Streaming Amplier Only)
The USB connections can be used for connecting the USB Wi-Fi Dongle and/ or extension cable. A USB drive
with audio on it can also be connected to the USB input and can be played from via the BluOS app.
Headphone Output
Headphones can be connected to the Streaming/ Integrated Ampliers by using the standard 3.5mm
headphone jack on the front of the product. When connecting headphones the speaker outputs will
automatically mute and the volume output goes to ‘safe’ headphone level. The Volume Display will change
to new volume level. Likewise when the headphones are removed, the speaker output level will be returned
to a ‘safe’ level.
IMPORTANT: Do not have the headphones connected and in use when carrying out a factory reset
or rmware update.
12v Trigger
These 3.5mm jack connections can be used to remotely turn the Streaming/ Integrated Ampliers on and
off by supplying a 12v signal to them. The output link will only work if there is an input to the product.
Either socket can be used for the input with its partner being used as the linked output, as a convenience to
allow a single 12V trigger output from a partnering system to be distributed (to a sub-woofer perhaps) with
a second cable.
IR Input
If the product is in a different room or cabinet, IR commands can be sent to the unit electrically via the
rear panel jack socket labelled Wired IR. Wired IR is compatible with many home automation installations
including Logitech Harmony, early Crestron and Control 4 installations. The Wired IR jack socket is an input
only and does not provide power, therefore, unsuitable for some remote IR-eye connections that are not
self-powered.
Power
The moulded IEC plug of the supplied mains lead should be plugged into the socket on the rear of the unit
rst and then plugged into the mains supply.
The mains fuse is located here in the small drawer attached to the mains input socket. The fuse is a T5AL
type.
NOTE: When entering standby, 10 - 15 seconds after the power button LED turns red, the loudspeaker
cones will move in and out. This is perfectly normal and will not cause any harm to the loudspeaker
or the amplier.
BluOS Playback
(Streaming Amplier only)
To take full advantage of the Streaming Amplier’s capabilities and features, you can use it as a music
streamer with the BluOS app. The app can be downloaded from your Apple, Android and Microsoft App
Store. Once downloaded follow the on-screen instructions to install and set up the app for use with your
Attessa Streaming Amplier.
When Standby Plus is enabled, the Streaming Amplier will be visible within the BluOS app and can be
woken from standby using it and begin playback.
roksan.com6