Owner's Manual
Table Of Contents
- Owners Manual
- Introduction
- Unpacking
- Directives
- AC Mains Supply
- Maintenance
- Location
- Streaming Amplifier Front Controls
- Streaming Amplifier Rear Connections
- Integrated Amplifier Front Controls
- Integrated Amplifier Rear Connections
- Remote Control
- USB Wi-Fi Dongle
- Connecting to the Wi-Fi
- Connections
- BluOS Playback
- MaestroUnite App
- Operation
- MQA
- Updates
- Warranty
- Troubleshooting
- Specifications
- Quick Start Guide
- Important Safety Instructions
IMPORTANT: For the app to nd the Streaming Amplier, you will need to select the BluOS input.
The BluOS module inside the amplier has an LED that is visible through the chassis. This provides
constant feedback with the connection status of the BluOS module. Below are a list of colour and ash
combinations. It can also be turned off or dimmed within the BluOS app menu.
Solid Green: The Player is in Hotspot Mode and is ready to be connected to the network. To setup your
player from Hotspot Mode, check out the wired or wireless setup options in the following support article.
https://support.bluos.net/hc/en-us/articles/360000057968
Flashing Green: The Player is attempting to connect to the network or the network cable is disconnected.
Solid Purple: The Player is not set up but Hotspot Mode has timed out after 15 minutes of idle.
Solid Blue: The Player is in Ready Mode connected to the network and ready to stream music.
Flicker Blue: Receiving IR Codes from a remote
Blinking Blue: The Player is Muted
Solid White: The Player is indexing the local music library on your network
Alternating White and Blue: Player is replicating or receiving an updated Index from other players
Solid Red: The Player is in Upgrade Mode waiting to perform an upgrade. If your player has entered
Upgrade Mode unexpectedly, please check out the following support article
https://support1.bluesound.com/hc/en-us/articles/204492653-My-Bluesound-Player-s-Mute-LED-
Button-stays-Red-when-Upgrading
Alternating Red/Green: The Player’s BluOS rmware upgrade is in progress.
MaestroUnite App
The Attessa range is accompanied by the MaestroUnite app. This app is used to create systems of CD
Transports, Integrated and Streaming Ampliers. It will also be the home to all user manuals, OTA (Over The
Air) updates and connecting the devices to the Wi-Fi network.
The mobile app is available for iOS and Android devices in your usual app store.
Once installed, follow these steps to create your Attessa system:
1. Touch on the “+” to
start creating a System
and name it.
2. Select the rst product
to add to the system.
3. Connect via bluetooth
by entering the code on
the screen of the product
4. Join your local Wi-Fi
network
5. Add the next product and
connect to it via Bluetooth as
done previously
6. Once 2 products have been
added, You’re Ready. Touch home
7. Your systems are visible in the
home screen where you can select
products to customise them
NOTE: When in a “System” the IR receiver is turned off on the CD Transport and the commands are
sent by BLE (Bluetooth Low Energy) from the Streaming/ Integrated Amplier. The Indicator icons
on the CD Transport will not operate when part of a system except when the CDt input is selected on the
Streaming/ Integrated amplier when they will become operational.
7Attessa Streaming/ Integrated Amplier