Specifications

BrightSign HD600

This information applies to a product under development. Its characteristics and specifications are subject to change without notice. Roku assumes no

obligation regarding future manufacturing unless otherwise agreed to in writing. www.rokulabs.com

3 RX+ 4 RC to ground

5 RC to ground 6 RX

7 RC to ground 8 RC to ground

USB

The HD600 has two high speed (400 mbit) USB host ports. The ports have the following pinout:

pin Description pin Description

1 VBUS 2 D-

3 D+ 4 Ground

DB15 VGA connector

The VGA connector is a able to output 1280 X 720 and 1024 X 768 computer RGB video. The connector

has the following pinout (NOTE: This pinout is only accurate for REVC and later. REVB has a hardware

bug on the pinout):

pin Description pin Description

1 RED analog video output 2 GREEN analog video output

3 BLUE analog video output 4 NC

5 Digital ground 6 Analog ground

7 Analog ground 8 Analog ground

9 NC 10 Digital ground

11 NC 12 NC

13 HSYNC output 14 VSYNC output

15 NC

Triple RCA Component HD video connector

The component triple RCA connector is a able to output the following formats:

• Composite video – from Blue jack.

• S-Video: Luma from Green jack and Chroma from Red jack

• 480P video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.

• 720P video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.

• 1080i video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.

To use the S-Video mode, you can use an adaptor that is wired as in this diagram: