User's Manual

Ver 0.3 ZyDAS WLAN Solution
- Select which key format “hexadecimal” or “ASCII” will be used from
the “Key Format” .
2.3.2.2 Press “WPA Encryption Setting” to enter the “WPA Setting” page
shown as Figure 2-4.
- You can select the WPA authentication protocol “TLS” , “PEAP” or
“TTLS” from “Protocol” filed.
- “TLS” Setting: you don’t fill out the User name and Password field,
but the Certificate need to be used. When apply the setting, the “WPA
Setting page” must be closed.
- “PEAP” Setting: The User name, Password and Certificate are needed.
When apply the setting, the “WPA Setting page” must be closed.
-“ TTLS” Setting: The User name, Password and Certificate are needed,
and you must select the phase 2 authentication type (PAP, CHAP,
MSCHAP, MSCHAPv2) from the “ Phase2Auth” drop down menu.
When apply the setting, the “WPA Setting page” must be closed.
- If you select “pre-share-key” protocol , you can write down your
password on the filed of “Passphrase” , the password length can be
selected from 8 bytes to 63 bytes (ASCII format) depend on user .
When apply the setting, the “WPA Setting page” must be closed.
Doc. No.WLANUS1211 ZyDAS Confidential Information
13
2005/10/25
2.3.3 “Profile ” group:
- Select the profile that has been saved previously from the “Profile
name” drop down menu, then press “Load ” button to load the status to
use.
- Write the profile name on the field of “Profile name”, and press the
“Save Current” button to save the current status on the profile.
- Select the profile name that wanted to delete from the “Profile name”
drop down menu, and press “Delete” button to delete it