PRO SERIES PUMP Installation & Parts Manual INLET Section title 1. 2. 3. 4. 5. 6. 7. 8. 9.
1. Safety: When installing and using this electrical equipment, basic safety precautions should always be followed, including: 1.1 WARNING !: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times 1.2 WARNING !: Risk of electric shock. Connect only to a grounding type receptacle protected by a ground-fault circuit interrupter (GFCI).
1.15 CAUTION! This pump is for use with permanently installed pools and may also be used with hot tubs and spas. Do not use with storable pools. A permanently installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage. A storage pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity. 1.16 CAUTION! --- Service tubing regularly, especially when refilling chemical container.
For low pressure applications, a brass injection fitting will fit a ½ NPT (American National Standard Taper Pipe Thread) connector or a ½ NPT hole tapped into heavy gage pipe. Push the vinyl tube through the fitting until it hits the bottom of the pipe, then pull it back about ¼ inch. This creates an outlet for chlorine away from the injector fitting and helps the injector fitting from becoming clogged.
Crystal buildup is seldom a problem with ROLA-CHEM pumps. However, it may be necessary to flush the pump hose and tubing. Use plain water or a weak solution of muriatic acid (1/2 pint muriatic acid to one gallon of water). CAUTION !: Always add acid to water; wear protective clothing, gloves, and safety glasses. CAUTION !: System pressure must be removed prior to releasing the tubing to prevent backflow.
7. PARTS LIST ITEM 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 PART No.
1/2 NPT TIMER POSITIONS .25" BRASS INJECTION FITTING INSTALLATION 29 30 31 ADAPTER CHECK VALVES BRASS COMPONENTS 14 13 33 18 35 36 32 15 34 16 17 9 8.75 10 7.75 12 9 11 6.
. TROUBLE SHOOTING PUMP PROBLEMS: Issue Pump does not operate, no noise, no motion. Cause Power Action Check power source, switches, circuit box, ground fault tripping, etc. Pump will not shut off with switch in ‘Timer’ position. Switch or timer Replace switch or timer switch. Pump motor turning but no movement in roller assly. Motor gearbox Replace motor Short hose life Worn or loose components Replace worn roller assembly/secure pump housing and cover.
