User Manual

Switching the power on and off
V-Accordion r
13
ENGLISH ENGLISH
ENGLISH ENGLISH
(3) Hold the adapter cable close to the right strap and wind
the attachment strip around it as shown.
The strip is fitted with a Velcro layer that holds it in place.
(4) Keep winding the attachment strip around the strap
until your assembly looks as follows:
(5) Reverse these steps to remove and disconnect the
adapter and/or MIDI and audio cables when you want to
stop playing.
Switching the power on and off
The power-on procedure depends on whether or not you are
using optional batteries.
Note: If you decide to use rechargeable AA batteries, be aware that they
cannot be recharged simply by leaving them in the FR-1’s compartment
and connecting the adaptor. You will need an external charging unit.
Note: Once the connections have been completed, turn on the power to
your various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to speakers
and other devices.
If you are using the supplied adaptor
(1) Connect the supplied adaptor to the FR-1’s DC IN
socket.
(2) Connect the adaptor to a wall outlet that meets the
specifications (see p. 32).
The adaptor should only be connected to a power source of
the type marked on its label. For details on the power con-
sumption, please refer to page 32.
(3) Turn down the output volume of the receiving audio
device.
You can also simply switch it off.
(4) Connect the FR-1’s OUTPUT sockets to the external
audio device using one or two 1/4” guitar cables. (One 1/
4” cable is supplied with the FR-1.)
Note: You can also connect headphones to the PHONES socket, in
which case you do not need to establish an audio connection.
(5) Turn the FR-1’s [VOLUME] knob A from the “POWER
OFF” position towards the right.
(6) Switch on the receiving audio device.
(7) Start playing.
Note: This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will oper-
ate normally.
—To switch off your system—
(8) Turn down the output volume of the receiving audio
device or switch it off.
(9) Turn the FR-1’s [VOLUME] knob A all the way to the left
(“POWER OFF”).
If you are using batteries
The FR-1 needs to be connected to an amplification system
of some sort (unless you want to use headphones).
(1) Install the required batteries into the FR-1’s compart-
ment (see p. 31).
(2) Turn down the output volume of the receiving audio
device.
You can also simply switch it off.
(3) Connect the FR-1’s OUTPUT sockets to the external
audio device using one or two 1/4” guitar cables. (One 1/
4” cable is supplied with the FR-1.)
Note: You can also connect headphones to the PHONES socket, in
which case you do not need to establish an audio connection.
(4) Turn the FR-1’s [VOLUME] knob A from the “POWER
OFF” position towards the right.
(5) Switch on the receiving audio device.
(6) Start playing.
—To switch off your system—
(7) Turn down the output volume of the receiving audio
device, or switch it off.
(8) Turn the FR-1’s [VOLUME] knob all the way to the left
(“POWER OFF”).
To the FR-1’s DC IN connector
AC adaptor
Power cord
To a wall outlet
Indicator