User Manual

108
Creating a Patch
Tone Delay Time
Specifies the time from when the key is pressed (or if the Delay
Mode parameter is set to “OFF-N” or “OFF-D,” the time from when
the key is released) until when the tone will sound.
Value: 0–127, Note
Tone Delay Time specifies the beat length for the synchronized
tempo when the tempo that specifies the elapsed time until the tone
is sounded (Patch Tempo) is synchronized with the tempo set in a
sequencer.
(Example)
For a tempo of 120 (120 quarter notes occur in 1 minute (60 seconds))
Tone Env Mode
When a loop waveform (p. 88) is selected, the sound will normally
continue as long as the key is pressed. If you want the sound to
decay naturally even if the key remains pressed, set this to “NO
SUS.”
Range: NO SUS, SUST
If a one-shot type Wave (p. 88) is selected, it will not sustain
even if this parameter is set to “SUST.”
Tone Receive Bender
(Tone Receive Pitch Bend Switch)
For each tone, specify whether MIDI Pitch Bend messages will be
received (ON), or not (OFF).
Value: OFF, ON
Tone Receive Expression
(Tone Receive Expression Switch)
For each tone, specify whether MIDI Expression messages will be
received (ON), or not (OFF).
Value: OFF, ON
Tone Receive Hold-1
(Tone Receive Hold Switch)
For each tone, specify whether MIDI Hold-1 messages will be
received (ON), or not (OFF).
Value: OFF, ON
If “NO SUS” is selected for Env Mode parameter, this setting
will have no effect.
Tone Receive Pan Mode
For each tone, specify how pan messages will be received.
Value
CONT: Whenever Pan messages are received, the stereo
position of the tone will be changed.
K-ON: The pan of the tone will be changed only when the
next note is played. If a pan message is received
while a note is sounding, the panning will not
change until the next key is pressed.
If “PFX (Patch Multi-Effects)” (p. 157) is on, the Tone Rx Pan
Mode setting is ignored.
The channels cannot be set so as not to receive Pan messages.
Tone Redamper Switch
You can specify, on an individual tone basis, whether or not the
sound will be held when a Hold 1 message is received after a key is
released, but before the sound has decayed to silence. If you want to
sustain the sound, set this “ON.” When using this function, also set
the Tone Receive Hold-1 parameter “ON.” This function is effective
for piano sounds.
Value: OFF, ON
Setting
Delay time
(half note)
1 second (60 / 60 =1 (second))
(quarter note)
0.5 seconds (60 / 120= 0.5 (seconds))
(eighth note)
0.25 seconds (60 / 240= 0.25 (seconds))
Fantom-G_r_e.book 108 ページ ２００８年１月３１日 木曜日 午後１２時１５分