User Manual

137
Creating a Live/Studio Set
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
Part Reverb Send Level
Sets the level of the signal sent to reverb for each part.
Value: 0–127
* External parts do not have this item.
Part EFX1 Send Level
(Expansion part effect 1: Send Level)
Sets the level of the signal sent to “EFX 1 (Effect) 1” for each part of
the expansion board.
Value: 0–127
* “EFX1 (Effect 1)” is an effect on the expansion board. The content of
the effect will depend on the expansion board that’s installed.
* Internal and External parts do not have this item.
Part EFX2 Send Level
(Expansion part effect 2: Send Level)
Sets the level of the signal sent to “EFX 1 (Effect) 1” for each part of
the expansion board.
Value: 0–127
* “EFX2 (Effect 2)” is an effect on the expansion board. The content of
the effect will depend on the expansion board that’s installed.
* Internal and External parts do not have this item.
Part Octave Shift
Adjusts the pitch of the part’s sound up or down in units of an
octave (+/-3 octaves).
Value: -3– +3
Part Transpose
Adjusts the pitch of the part’s sound up or down in semitone steps.
Value: -5– +6
Part Coarse Tune
Adjusts the pitch of the part’s sound up or down in semitone steps
(+/-4 octaves).
Value: -48– +48
* EXP 1 and EXP 2 parts will depend on the expansion board that is
installed.
* External parts do not have this item.
Part Fine Tune
Adjusts the pitch of the part’s sound up or down in 1-cent steps (+/-
50 cents).
Value: -50– +50
One cent is 1/100th of a semitone.
* EXP 1 and EXP 2 parts will depend on the expansion board that is
installed.
* External parts do not have this item.
Pitch
Coarse Tune and Octave Shift
The Coarse Tune and Fine Tune parameters, along with the
Octave Shift parameter, can all be seen as doing the same thing
to the sound, i.e., changing the pitch of the sound. For example,
if C4 (Middle C) is played with the Coarse Tune parameter set
to “+12,” the note produced is C5 (one octave above C4). For
example, if C4 (Middle C) is played with the Octave Shift
parameter set to “+1,” the note produced is C5 (one octave
above C4).
However, internally these function very differently. When the
Coarse Tune parameter is set to “+12,” the pitch itself is raised
one octave. On the other hand, when the Octave Shift parameter
is set to “+1,” it is the same as pressing the keys one octave up.
In other words, use the Coarse Tune parameter when changing
the pitch, and the Octave Shift parameter when you want to
shift the entire keyboard, for example, when the number of keys
is insufficient.
Fantom-G_r_e.book 137 ページ ２００８年１月３１日 木曜日 午後１２時１５分