User Manual

200
Using the Pads
This pad mode allows you to use the pads to select parts (1–16) and
banks (INT/EXP1/EXP2/EXT).
1. Press [PAD MODE], and then press pad [13] (PART
SELECT).
• Press a pad to select the current part. The number of parts will
depend on the sound generator mode.
• The pad corresponding to the current part will be blinking. The
pads for other parts will light. Pads not used will be dark.
• You can press [ROLL] (BANK) to switch banks (1–4). → p. 189
* The number of parts on an expansion board will depend on the
expansion board.
By pressing [PAD SETTING] you
can check the current pad status.
This pad mode lets you use the pads to mute (silence) parts (1–16)
and banks (INT/EXP1/EXP2).
1. Press [PAD MODE], and then press pad [14] (PART MUTE).
• You can press [ROLL] (BANK) to switch banks (1–3). → p. 189
• Press a pad to switch the corresponding part between muted/
play.
* The number of internal sound generator parts will depend on the
sound generator mode.
* The number of parts on an expansion board will depend on the
expansion board.
• Pads whose corresponding part is muted will blink. The pads of
other parts will be lit. Unused pads will be dark.
By pressing [PAD SETTING] you
can check the current pad status.
13 PART SELECT
(Using the Pads to Select Parts)
Mode
Number of parts
Single
1
Live 8
Studio 16
Pad
Bank name
1
INT (internal sound generator)
2 EXP1 (expansion board 1)
3 EXP2 (expansion board 2)
4 EXT (external MIDI output)
Checking the Pad Status
14 PART MUTE
(Using the Pads to Mute Parts)
Pad Bank name
1 INT (internal sound generator)
2 EXP1 (expansion board 1)
3 EXP2 (expansion board 2)
Mode
Number of parts
Single
3
Live 8
Studio 16
Checking the Pad Status
Fantom-G_r_e.book 200 ページ ２００８年１月３１日 木曜日 午後１２時１５分