User Manual

222
Recording MIDI
Realtime recording is the recording method in which your keyboard
performance and controller operations are recorded exactly as you
perform them. Choose this recording method when you want to
capture the nuances of your performance.
1. Make sure that you’ve made the appropriate preparations
for recording as described in “Recording into a Song” (p.
218) or “Recording into a Phrase” (p. 220).
2. Press [REC].
The [REC] indicator will blink, and the Realtime Rec Standby
window will appear.
In this window you can set various parameters related to
realtime recording.
3. Use [CURSOR] to move the cursor to the various
parameters, and turn the VALUE dial or use [INC] [DEC] to
set them.
For details on the parameters, refer to “Realtime Rec Standby
Parameters” (p. 222).
4. When you’ve finished making settings in the Realtime Rec
Standby window, press [PLAY] or [F8 (Start)].
The Realtime Rec Standby window will close, the [REC]
indicator will change from blinking to lit, and recording will
start.
When recording starts, the Realtime Recording window will
appear.
To close this window, press [F8 (Close)] or [PLAY]. To open it
again, press [PLAY].
In this window you can perform the following operations.
• Realtime erase (Erase p. 224)
• Rehearsal function (Rehearsal p. 225)
For details on these operations, refer to the corresponding page.
5. When you’ve finished recording, press [STOP].
The [REC] indicator will go dark.
This section explains the Realtime Rec Standby parameters.
Rec Mode
Selects how recording is to take place.
Value
MIX:
Mix-recording will be carried out. Normally, you
will record using this method. If a performance has
already been recorded on the recording-destination
phrase, your newly recorded performance will be
added to the existing performance without erasing
it. By using this in conjunction with Loop-recording,
you can record repeatedly over a specified area
without erasing the previously recorded
performance. For example, this is a convenient way
to record a drum performance one instrument at a
time; bass drum
→ snare drum → hi-hat, etc.
REPLACE: Replace-recording will be carried out. If a
performance has already been recorded on the
recording-destination phrase, it will be erased as
you record your new performance. Use this
when you want to re-record.
Count In
Selects how recording is to begin.
Value
OFF: Recording will begin immediately when you
press [PLAY].
1 MEAS: When you press [PLAY], a count (playback) will
begin one measure before the recording-start
location, and recording will begin when you
reach the recording-start location.
2 MEAS: When you press [PLAY], a count (playback) will
begin two measures before the recording-start
location, and recording will begin when you
reach the recording-start location.
WAIT NOTE: As an alternative to pressing [PLAY], you can
play the keyboard, strike a pad, or press the
Hold pedal to start recording.
Recording Your Performance
Just as You Play It
(Realtime Recording)
Basic Procedure for Realtime Recording
Realtime Rec Standby Parameters
Fantom-G_r_e.book 222 ページ ２００８年１月３１日 木曜日 午後１２時１５分