User Manual
Table Of Contents
- Introduction
- Contents
- Main Features
- USING THE UNIT SAFELY
- Important Notes
- Names of Things and What They Do
- Before You Play
- Listening to Songs
- Performing
- Performing with a Variety of Sounds
- Simulating the Way that Sounds are Created on an Organ (Tone Wheel)
- Performing with Two Layered Tones (Dual Play)
- Performing with Different Tones in the Left and Right Sides of the Keyboard (Split Play)
- Changing the Volume Balance for Dual Play and Split Play
- Adjusting the Keyboard Sensitivity (Key Touch)
- Adding Reverberation to Sounds (Reverb Effect)
- Adding a Variety Effects to the Sound (Effects)
- Adding a Spinning Sound to Organ Tones (Rotary Effect)
- Transposing the Key of the Keyboard or Song Playback (Transpose)
- Performing with the Metronome
- Adding Liveliness to the Sound (Sound Control)
- Changing the Tonal Quality (Equalizer)
- Performing with Audio Files (Audio Key)
- Creating a Piano Sound to Your Taste (Piano Designer)
- Playing Along with Rhythms
- What is Session Partner?
- Performing Along with Session Partner
- Selecting a Rhythm
- Changing a Rhythm’s Tempo
- Selecting a Rhythm’s Chord Progression
- Performing with the Chord Progression Specified in the Left Hand (Chord Progression Off)
- Changing the Rhythm Pattern (Original/Variation)
- Recording the Chord Progression
- Saving Your Favorite Performance Settings
- Recording
- Saving a Performance
- Various Settings
- Connecting Other Equipment
- Appendices
46
Performing
You can change the split point (the key at which the keyboard is divided).
The split point can be set to any value from B1 through B6.
This is set to “F 3” when the instrument is turned on.
This setting remains in effect until you turn off the power.
fig.SplitPoint-3-e.eps_77
fig.Panel-Split-4.eps
1.
Hold down the [Split] button and press a key set as the split point.
The key you pressed becomes the split point, and appears in the display.
fig.d-spltpoint.eps
The key being used as the split point belongs to the left-hand section of the keyboard.
The display will return to its previous state when you release the [Split] button.
The name of the lower tone is displayed while you hold down the [Split] button.
Changing the Keyboard’s Split Point
Split Point (Power-up default: F 3)
Range in which you can specify the split point (B1–B6)
C1 B1 B6A0 C2 C3 C4 C5 C6 C7 C8
FP-7-e.book 46 ページ 2007年7月12日 木曜日 午後3時47分