User Manual
Table Of Contents
- Introduction
- Contents
- Main Features
- USING THE UNIT SAFELY
- Important Notes
- Names of Things and What They Do
- Before You Play
- Listening to Songs
- Performing
- Performing with a Variety of Sounds
- Simulating the Way that Sounds are Created on an Organ (Tone Wheel)
- Performing with Two Layered Tones (Dual Play)
- Performing with Different Tones in the Left and Right Sides of the Keyboard (Split Play)
- Changing the Volume Balance for Dual Play and Split Play
- Adjusting the Keyboard Sensitivity (Key Touch)
- Adding Reverberation to Sounds (Reverb Effect)
- Adding a Variety Effects to the Sound (Effects)
- Adding a Spinning Sound to Organ Tones (Rotary Effect)
- Transposing the Key of the Keyboard or Song Playback (Transpose)
- Performing with the Metronome
- Adding Liveliness to the Sound (Sound Control)
- Changing the Tonal Quality (Equalizer)
- Performing with Audio Files (Audio Key)
- Creating a Piano Sound to Your Taste (Piano Designer)
- Playing Along with Rhythms
- What is Session Partner?
- Performing Along with Session Partner
- Selecting a Rhythm
- Changing a Rhythm’s Tempo
- Selecting a Rhythm’s Chord Progression
- Performing with the Chord Progression Specified in the Left Hand (Chord Progression Off)
- Changing the Rhythm Pattern (Original/Variation)
- Recording the Chord Progression
- Saving Your Favorite Performance Settings
- Recording
- Saving a Performance
- Various Settings
- Connecting Other Equipment
- Appendices
55
Performing
1.
Press the [Display] button several times so it’s lit in orange.
The tempo is displayed.
fig.d-Tempo.eps
2.
Press the [-] or [+] button to adjust the tempo.
The tempo is set in terms of the value of a quarter note, with possible values ranging from 10 up
to 500.
The volume of the metronome can be adjusted, with ten volume levels available.
This is set to “5” when the instrument is turned on.
1.
While holding down the [Metronome] button, press the [-] or [+] button to
adjust the volume.
The display will indicate the metronome volume.
fig.d-MetroVol.eps
When the metronome volume is set to “0,” the metronome sound does not play.
You can also adjust the volume of the metronome by turning the [Balance] knob while
you hold down the [Metronome] button.
Changing the Tempo
Changing the Volume of the Metronome
NOTE
FP-7-e.book 55 ページ 2007年7月12日 木曜日 午後3時47分