User Manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Contents
- Features
- Panel Descriptions
- Setting Up the Kit
- Choosing a Drum Kit
- Playing the Drum Kit
- Creating Your Own Drum Kit
- Playing with the Metronome (Click)
- Playing with a CD, Tape, or MD (Via MIX IN Jack)
- COACH Mode
- Pad Adjustments
- Hi-Hat Control Pedal Adjustment
- Factory Reset (Restoring the Factory Settings)
- About the Pads
- Pad Configuration Possibilities
- Pad and Trigger Settings
- Selecting the Pad Type (Trigger Type)
- Adjusting Pad Sensitivity
- Setting the Minimum Levels for the Pads (Threshold)
- How Playing Dynamics Changes the Volume (Velocity Curve)
- Adjusting the Trigger Signal Detection Time (Scan Time)
- Detecting Trigger Signal Attenuation and Cancelling Incorrect Triggering (Retrigger Cancel)
- Eliminate Crosstalk Between Pads (Crosstalk Cancel)
- Double Triggering Prevention (Mask Time)
- Rim Shots Response (Rim Sensitivity)
- Rim/Edge Dynamic Response (Rim Gain)
- MIDI Settings
- Troubleshooting / Error Messages
- Drum Kit List
- Drum Instrument List
- MIDI Implementation Chart
- Specifications
- Index
51
Pad and Trigger Settings
1.
Hold down [LEVEL/PAN] and press [TEMPO].
[EDIT] flashes.
2.
Hit the pad you wish to set.
The trigger indicator for the struck pad lights.
3.
Press [+] or [-] to select the trigger type.
* The RT-7K, RT-5S, and RT-3T are Roland acoustic drum triggers.
4.
Repeat Steps
2
–
3
to set the trigger type for each pad.
This setting applies to both the head and rim.
5.
Strike the pads and press the pedals to check the following.
• Are sounds being played with all pads and pedals?
• Is the right instrument for each pad being played?
If the correct sound is not being played, check the pad settings once more and refer to
“Troubleshooting”
(p. 65).
6.
To make other settings, press [EDIT] to select another trigger parameter.
7.
When you’re finished, press [DRUM KIT]; the [EDIT] light goes off.
Do not turn off the power without the [EDIT] light having gone out. Otherwise you will lose
the changes you have just made.
The “Xtalk Cancel” (Crosstalk Cancel) value does not change when the trigger type is
changed. Adjust this as necessary in accordance with the pad you are using and the playing
conditions (p. 57).
Pad Value (Display)
PD-8
PD-6, PD-7, PD-9
PD-80, PD-80R, PD-85
PD-100, PD-105
PD-120, PD-125
KD-7, KD-8
KD-80, KD-85, KD-120
CY-8
CY-6, CY-12R/C, CY-12H, CY-14C, CY-15R
RT-7K
RT-5S
RT-3T
TD-3_e.book 51 ページ 2005年5月20日 金曜日 午後4時57分