User Manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Contents
- Features
- Panel Descriptions
- Setting Up the Kit
- Choosing a Drum Kit
- Playing the Drum Kit
- Creating Your Own Drum Kit
- Playing with the Metronome (Click)
- Playing with a CD, Tape, or MD (Via MIX IN Jack)
- COACH Mode
- Pad Adjustments
- Hi-Hat Control Pedal Adjustment
- Factory Reset (Restoring the Factory Settings)
- About the Pads
- Pad Configuration Possibilities
- Pad and Trigger Settings
- Selecting the Pad Type (Trigger Type)
- Adjusting Pad Sensitivity
- Setting the Minimum Levels for the Pads (Threshold)
- How Playing Dynamics Changes the Volume (Velocity Curve)
- Adjusting the Trigger Signal Detection Time (Scan Time)
- Detecting Trigger Signal Attenuation and Cancelling Incorrect Triggering (Retrigger Cancel)
- Eliminate Crosstalk Between Pads (Crosstalk Cancel)
- Double Triggering Prevention (Mask Time)
- Rim Shots Response (Rim Sensitivity)
- Rim/Edge Dynamic Response (Rim Gain)
- MIDI Settings
- Troubleshooting / Error Messages
- Drum Kit List
- Drum Instrument List
- MIDI Implementation Chart
- Specifications
- Index
58
Pad and Trigger Settings
When playing a kick pad the beater can bounce back and hit the pad a second time immediately after the
intended note—with acoustic drums sometimes the beater stays against the head—this causes a single hit
to “double trigger” (two sounds instead of one). The Mask Time setting helps to prevent this. Once a pad
has been hit, any additional trigger signals occurring within the specified “MASKTIME” (0–64 msec) will
be ignored.
When set to a high value, it will be difficult to play very quickly. Set this to as low a value as you can.
fig.mask time.e
1.
Hold down [LEVEL/PAN] and press [TEMPO].
[EDIT] flashes.
2.
Press [EDIT] a few times until “ ” is displayed.
“ ” appears in the display, then the mask time value is indicated.
3.
Hit the pad you wish to set.
The trigger indicator for the struck pad lights.
4.
Press [+] or [-] to set the mask time.
Mask Time:
0–64 ms (4 ms steps)
Making the settings
Adjust the “Mask Time” value while playing the pad.
When using a kick trigger, try to let the beater bounce back and hit the head very quickly, then raise the
“Mask Time” value until there are no more sounds made by the beater rebound.
If two or more sounds are being produced when you strike the head just once, then adjust
Retrigger Cancel.
5.
Press [EDIT] to continue editing other settings.
6.
When you’re finished, press [DRUM KIT]; the [EDIT] light goes off.
Do not turn off the power without the [EDIT] light having gone out. Otherwise you will lose
the changes you have just made.
Double Triggering Prevention (Mask Time)
Time
Mask Time
Sound not produced
TD-3_e.book 58 ページ 2005年5月20日 金曜日 午後4時57分