User manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Quick Page Reference Table
- Contents
- Contents of the Package
- Panel Descriptions
- Driver Installation
- About the Operating Modes
- Performing
- Setting the MIDI Transmit Channel (MIDI CHANNEL)
- Switching Sounds
- Shifting the Pitch of the Keyboard
- Using the Lever to Modify the Sound
- Using the D-BEAM to Modify the Sound
- Using the Knobs to Modify the Sound
- Using the Pedals to Modify the Sound
- Using Aftertouch to Modify the Sound
- Halting Stuck Notes (PANIC)
- Changing the A-49 Settings
- Changing the Velocity Curve (VELO CURVE)
- Specifying the Keyboard Velocity Value (KEY VELO)
- Switching the Function of the [C2] Knob in SuperNATURAL Mode (SN SETTING)
- Assigning Functions to the Knobs, Buttons, and Jacks
- Changing the Direction of Value Increases for the Knobs, D-BEAM Controller, Buttons, and Pedals (CTRL DIR)
- Selecting the Dedicated Driver or the Generic Driver
- Restoring the Factory Settings (FACT RESET)
- Troubleshooting
- Main Specifications
- Index
Panel Descriptions
12
Rear Panel
USB COMPUTER port
Use a USB cable to connect
the A-49 to your computer.
* Install the driver in your
computer before you make
this connection (p. 13).
HOLD jack
You can connect a pedal
switch (DP-2, DP-10; avail-
able separately) here and
use it as a hold pedal (p. 32).
EXPRESSION jack
You can connect an expression
pedal (EV-5, EV-7; available
separately) here and use it to
control various parameters and
functions (p. 32).
* Use only the specied expression pedal (EV-5,
EV-7; sold separately). By connecting any other
expression pedals, you risk causing malfunction
and/or damage to the unit.
MIDI OUT
connector
You can connect
this to the MIDI IN
connector of another
MIDI device so that the
A-49 can transmit MIDI
messages to it.
* To prevent malfunction and equipment failure, always turn down the volume, and turn o all
the units before making any connections.