User manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Quick Page Reference Table
- Contents
- Contents of the Package
- Panel Descriptions
- Driver Installation
- About the Operating Modes
- Performing
- Setting the MIDI Transmit Channel (MIDI CHANNEL)
- Switching Sounds
- Shifting the Pitch of the Keyboard
- Using the Lever to Modify the Sound
- Using the D-BEAM to Modify the Sound
- Using the Knobs to Modify the Sound
- Using the Pedals to Modify the Sound
- Using Aftertouch to Modify the Sound
- Halting Stuck Notes (PANIC)
- Changing the A-49 Settings
- Changing the Velocity Curve (VELO CURVE)
- Specifying the Keyboard Velocity Value (KEY VELO)
- Switching the Function of the [C2] Knob in SuperNATURAL Mode (SN SETTING)
- Assigning Functions to the Knobs, Buttons, and Jacks
- Changing the Direction of Value Increases for the Knobs, D-BEAM Controller, Buttons, and Pedals (CTRL DIR)
- Selecting the Dedicated Driver or the Generic Driver
- Restoring the Factory Settings (FACT RESET)
- Troubleshooting
- Main Specifications
- Index
Driver Installation
14
5. When a conrmation screen regarding user account control appears, click [Yes] or
[Continue].
6. When “The A-Series Keyboard Driver will be installed on your computer” appears,
click [Next].
7. Click [Next] again.
Windows 7/Windows Vista
If a dialog box regarding Windows security appears, click [Install].
Windows XP
If the “Software Install” dialog box appears, click [Continue] to proceed with the installation.
If you cannot proceed, click [OK] to cancel the installation. Change the settings as described
in “Driver Signing Options Setting (Windows XP)” (p. 46) and try installing again.
8. When “Ready to install the driver.”
appears, connect the USB cable of the
A-49 to the computer.
* Turn down the volume on any peripheral
devices before connecting the USB cable.
* This unit is equipped with a protection
circuit. A brief interval (a few seconds)
after turning the unit on is required before
it will operate normally.
It may take several minutes for the driver to be installed.
Windows 7/Windows Vista
If other messages appear, follow the instructions on the screen. The driver will be installed
automatically.
Windows XP
“Found new hardware” will appear in the lower-right corner of the screen.
A-49
rear panel
Windows
Windows 7/Windows Vista
Windows XP