User manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Quick Page Reference Table
- Contents
- Contents of the Package
- Panel Descriptions
- Driver Installation
- About the Operating Modes
- Performing
- Setting the MIDI Transmit Channel (MIDI CHANNEL)
- Switching Sounds
- Shifting the Pitch of the Keyboard
- Using the Lever to Modify the Sound
- Using the D-BEAM to Modify the Sound
- Using the Knobs to Modify the Sound
- Using the Pedals to Modify the Sound
- Using Aftertouch to Modify the Sound
- Halting Stuck Notes (PANIC)
- Changing the A-49 Settings
- Changing the Velocity Curve (VELO CURVE)
- Specifying the Keyboard Velocity Value (KEY VELO)
- Switching the Function of the [C2] Knob in SuperNATURAL Mode (SN SETTING)
- Assigning Functions to the Knobs, Buttons, and Jacks
- Changing the Direction of Value Increases for the Knobs, D-BEAM Controller, Buttons, and Pedals (CTRL DIR)
- Selecting the Dedicated Driver or the Generic Driver
- Restoring the Factory Settings (FACT RESET)
- Troubleshooting
- Main Specifications
- Index
Performing
28
Transmitting a Program Change number (PRGM CHANGE)
Value 0–127
0–9
For details on this value, refer to p. 8.
Shifting the Pitch of the Keyboard
Changing the octave (Octave Shift)
You can raise or lower the pitch range of the keyboard (Octave Shift) by using the [+] [–] buttons.
You can change this setting in the range of -4 to 5 octaves.
The OCTAVE/TRANSPOSE indicator will light to indicate the current octave shift setting (p. 11).
If you press the [+] button and [–] button simultaneously, this setting will be reset to 0.
Changing the pitch (Transpose)
You can transpose the pitch in semitone step by using the [+] [–] buttons while holding down the
[TRANSPOSE] button.
You can change this setting in the range of -6 to 5.
The OCTAVE/TRANSPOSE indicator will light to indicate the current transpose setting (p. 11).
When the [TRANSPOSE] button is turned on, the transposition setting is enabled. When the
[TRANSPOSE] button is turned o, the transposition setting is disabled.
If you press the [TRANSPOSE] button, the [+] button, and the [–] button simultaneously, this
setting will be reset to 0.