User manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Quick Page Reference Table
- Contents
- Contents of the Package
- Panel Descriptions
- Driver Installation
- About the Operating Modes
- Performing
- Setting the MIDI Transmit Channel (MIDI CHANNEL)
- Switching Sounds
- Shifting the Pitch of the Keyboard
- Using the Lever to Modify the Sound
- Using the D-BEAM to Modify the Sound
- Using the Knobs to Modify the Sound
- Using the Pedals to Modify the Sound
- Using Aftertouch to Modify the Sound
- Halting Stuck Notes (PANIC)
- Changing the A-49 Settings
- Changing the Velocity Curve (VELO CURVE)
- Specifying the Keyboard Velocity Value (KEY VELO)
- Switching the Function of the [C2] Knob in SuperNATURAL Mode (SN SETTING)
- Assigning Functions to the Knobs, Buttons, and Jacks
- Changing the Direction of Value Increases for the Knobs, D-BEAM Controller, Buttons, and Pedals (CTRL DIR)
- Selecting the Dedicated Driver or the Generic Driver
- Restoring the Factory Settings (FACT RESET)
- Troubleshooting
- Main Specifications
- Index
Performing
31
Using the Knobs to Modify the Sound
You can modify the sound by turning the [C1] [C2] knobs.
Knob Function
[C1] knob Transmits a Cuto (CC#74) message.
[C2] knob Transmits a Resonance (CC#71) message.
* The eect that’s applied will depend on the sound module. For details, refer to the owner’s
manual of your sound module.
MEMO
You can change the functions that are assigned to the [C1] [C2] knobs. For details, refer to
“Assigning Functions to the Knobs, Buttons, and Jacks” (p. 37).