User manual
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Quick Page Reference Table
- Contents
- Contents of the Package
- Panel Descriptions
- Driver Installation
- About the Operating Modes
- Performing
- Setting the MIDI Transmit Channel (MIDI CHANNEL)
- Switching Sounds
- Shifting the Pitch of the Keyboard
- Using the Lever to Modify the Sound
- Using the D-BEAM to Modify the Sound
- Using the Knobs to Modify the Sound
- Using the Pedals to Modify the Sound
- Using Aftertouch to Modify the Sound
- Halting Stuck Notes (PANIC)
- Changing the A-49 Settings
- Changing the Velocity Curve (VELO CURVE)
- Specifying the Keyboard Velocity Value (KEY VELO)
- Switching the Function of the [C2] Knob in SuperNATURAL Mode (SN SETTING)
- Assigning Functions to the Knobs, Buttons, and Jacks
- Changing the Direction of Value Increases for the Knobs, D-BEAM Controller, Buttons, and Pedals (CTRL DIR)
- Selecting the Dedicated Driver or the Generic Driver
- Restoring the Factory Settings (FACT RESET)
- Troubleshooting
- Main Specifications
- Index
Changing the A-49 Settings
40
Changing the Direction of Value Increases for the Knobs,
D-BEAM Controller, Buttons, and Pedals (CTRL DIR)
Operate either
Button Setting Explanation
[+] button
POSITIVE
(default)
Moving the knob toward the right will increase the value. Moving
your hand closer to the D-BEAM controller will increase the value, and
moving it away from the D-BEAM controller will decrease the value.
Pressing a button will increase the value. Pressing a pedal will increase
the value.
[–] button REVERSED The opposite will occur.
Selecting the Dedicated Driver or the Generic Driver
Normally, you can leave this set to “ADVANCED.”
Button Setting Explanation
[+] button
ADVANCED
(default)
The dedicated driver described in “Driver Installation” (p. 13) will be
used.
[–] button GENERIC
The generic driver provided by the operating system will be used.
This is convenient if you don’t have the dedicated driver, or if you’re
unable to install the dedicated driver.
* After changing the setting, disconnect the unit’s USB cable, and then reconnect it to reect
setting.