User`s manual

Chapter 2 Operation
2-2 Loading and Cutting Off Media
45
When you begin take-up, take care to ensure that the end of the media does not become rolled or creased.
8. Take up the media onto the paper pipe.
➊
Close the front cover.
➋


 Turn on the sub power switch.


 When the sub power switch lights up,
press
.
The key flashes, then remains steadily lit.
After lights up, proceed in the sequence
indicated below. If the key doesn't light up, refer
to the following.
☞ p 108 "The Machine Doesn't Run"
➌
Release the stopper for the take-up dancer roller.
➍
While supporting the take-up dancer roller with
your hand, use
to feed out the media and
take it up on the paper pipe a little at a time.
Take up the media for one turn or more.
Continue to support the dancer roller with your hand
until the take-up unit starts to take up the media. While
keeping the dancer roller flipped back toward you to
keep the media from becoming slack, feed the media
a little at a time.
When the take-up unit begins to take up the media,
release the dancer roller and feed the media a little at
a time.
After taking up the media for one turn or more, check
to make sure the two edges of the media are aligned
with the guide marks on the paper pipe.
Steadily lighted Flashing
Steadily lighted
Guide marks on the
paper pipe