Owner`s manual

37
Time 0.1–6.0 sec.
Time over which the reverb
sound decays
Low Damp Freq 20–1000 Hz
Frequency below which the low
range of the reverb sound will be
dampened
Low Damp 1–100%
Amount of attenuation for LF
damp
(100%: no effect)
High Damp Freq 1000–10000 Hz
Frequency above which the high
range of the reverb sound will be
dampened
High Damp 1–100 %
Amount of attenuation for HF
damp
(100%: no effect)
High Cut Freq 1000–10000 Hz
Frequency above which the high
range of the final output sound
will be cut
Type: 6 (SRV ROOM)/ 7 (SRV HALL)/ 8 (SRV PLATE)
Pre Delay 0.0–100 ms
Delay time from the original
sound until the reverb is heard
Time 0–127
Time over which the reverb
sound decays
Size 1–8 Size of the room or hall
High Cut Freq
160 Hz–12500 Hz,
BYPASS
Frequency above which the high
range of the final output sound
will be cut
(BYPASS: no cut)
Density 0–127 Density of the reverberation
Diffusion 0–127
Change in reverb density over
time
With higher values, the sound
will become denser over time.
This is particularly noticeable
with longer reverb times.
Parameter Value Description
LF Damp Freq
50–4000 Hz
Frequency below which the low
range of the reverb sound will be
dampened
LF Damp Gain -36–0 dB
Amount of attenuation for LF
damp
(0: no effect)
HF Damp Freq
4000 Hz–12500
Hz
Frequency above which the high
range of the reverb sound will be
dampened
HF Damp Gain -36–0 dB
Amount of attenuation for HF
damp
(0: no effect)
Parameter Value Description
ARX-03_e.book 37 ページ ２００９年２月２６日 木曜日 午前９時６分