Owner`s manual

38
Here you can assign controllers to switch between Unison mode and
Stack mode, or to switch between performance variations.
For example, you could use a pedal to switch between Unison mode
and Stack mode.
Bender settings (Bend/Hold screen)
Here you can specify bender range for each instrument.
.
Settings for each instrument
* For the SuperNATURAL brass (BRASS) sounds, setting the bend
range (RANGE) to 3 or higher will simulate the discontinuous
pitch change that is typical of brass instruments, instead of the
normal smooth pitch change. When you apply a downward
bend, the sound will behave in the manner distinctive of brass
instruments, meaning that the volume will also decrease.
Settings for each patch
Controller Assignments (CONTROL)
Parameter
Value Description
Play/Standby
PLAY,
STANDBY
Turns the sound of each player on/off.
Bend Range Up 0–12
Specifies the amount of pitch change for
BendUp
This setting is in semitone steps (valid when
Bender Mode is ”NORMAL,” ”LOCK1” or
”LOCK2”).
From Main Screen
F7>F3
(on the Fantom-G)
Bend Range Down
0–12
Specifies the amount of pitch change for
BendDown
This setting is in semitone steps (valid when
Bender Mode is ”NORMAL,” ”LOCK1” or
”LOCK2”).
Parameter
Value Description
Bender Mode
NORMAL,
LOCK1,
LOCK2,
COMBI
Specifies what happens when you operate the
bender
NORMAL: Normal operation
LOCK1:
Bend will apply only to the first-played key.
LOCK2:
No change will be produced by returning the
bender.
COMBI:
This mode allows you to express the subtle pitch
changes that are distinctive of a brass instrument.
The proportion of breath noise will increase
when you operate the bender in the Down
direction.This lets you freely control the
breathiness at the beginning or end of a note.
Parameter Value Description
ARX-03_e.book 38 ページ ２００９年２月２６日 木曜日 午前９時６分