Owner`s manual

44
03: AUTO WAH
A filter that turns on and off to create a cyclical change in timbre.
fig.MFX08
04: HEXA-CHORUS
Uses a six-phase chorus (six layers of chorused sound) to give richness and
spaciousness to the sound.
fig.MFX17
Parameter
Value Description
Filter Type
LPF, BPF
Type of filter
LPF:
The wah effect is applied over a wide fre-
quency range.
BPF:
The wah effect is applied over a narrow
frequency range
Rate #
0.05–
10.00 Hz,
note
Frequency of modulation
Depth # 0–127 Depth of modulation
Sens 0–127
Adjusts the sensitivity with which the filter
is controlled.
Manual # 0–127
Adjusts the center frequency at which the
wah effect is applied.
Peak 0–127
Adjusts the amount of the wah effect that
occurs in the range of the center frequen-
cy.
Set a higher value for Q to narrow the
range to be affected.
Level 0–127 Output level
Auto Wah
L out
R out
L in
R in
Parameter
Value Description
Pre Delay 0.0–100.0 ms
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Depth 0–127 Depth of modulation
Pre Delay
Deviation
0–20
Adjusts the differences in Pre Delay be-
tween each chorus sound.
Depth
Deviation
-20– +20
Adjusts the difference in modulation
depth between each chorus sound.
Pan
Deviation
0–20
Adjusts the difference in stereo location
between each chorus sound.
0:
All chorus layers are in the center.
20:
The chorus layers are spaced at 60-de-
gree intervals relative to the center.
Balance #
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output level
Balance W
Balance W
L in
R in
L out
R out
Hexa Chorus
Balance D
Balance D
ARX-03_e.book 44 ページ ２００９年２月２６日 木曜日 午前９時６分