User`s manual

4-2 Setting the Y-axis Origin
46
Chapter 4 Setting the Origins
 
WARNING: This procedure makes
the machine operate. Before you
perform this procedure, check to
make sure that operation of the
machine will not create any hazard
or danger.
Click [Continue].

When operation stops and the dis-
played window changes, rotate the
spindle a half-turn by hand.

WARNING: This procedure makes
the machine operate. Before you
perform this procedure, check to
make sure that operation of the
machine will not create any hazard
or danger.
Click [Continue].

Click [OK] to nish detection.
Detach the sensor.
Continue by proceeding with "Step 2: Set the Y-axis Origin (Call Up the A-axis Center)."
To Make the Tool Descend Rapidly
When it takes a long time for the tool to make contact with the Z-origin sensor, turn the hand wheel on the handy panel
counterclockwise. Be careful not to make the tool collide with the sensor. A collision makes accurate detection impossible.
If a collision occurs, redo the operation from the beginning.