User`s manual

52
Chapter 4 Setting the Origins
4-5 Fine-tuning the Y- and Z-axis Origins
Fine-tuning the Y- and Z-axis Origins
When you want to make the position of the A-axis center detected using the origin sensor even more precise, refer to the
method described below.
Procedure

WARNING: This procedure makes
the machine operate. Before you
perform this procedure, check to
make sure that operation of the
machine will not create any hazard
or danger.
In VPanel, click the [Move Tool] icon.
If you're in the NC-code mode, then
select the workpiece coordinate syst-
em you're using.
Select [Y Origin].
Click [Move].

Move the Y axis by the amount of
the adjustment value.
Click [Close].

In VPanel, click the [Base Point] icon.
If you're in the NC-code mode, then
select the workpiece coordinate syst-
em you're using.
Select [Y Origin].
Click [Apply].
The method just described is for ne-tuning the Y-axis origin. Use the same method for the Z-axis origin as well.
For information on how to determine the adjustment value, refer to the following section.