User`s manual

2-3 Setting the Y-axis Origin Point for the Center of Rotation

Chapter 2 Preparation

➎

Run the sensor cable from the back to a location over the

table.

Insert the sensor cable into the hole on the back of the

sensor.

Install the Y-origin detection pin.

➊

Insert the Y-origin detection pin into the collet.

➋

Insert the collet and tool from underneath.

While supporting the pin to keep if from falling, turn the

collet to secure it in place.

➌

Tighten the collet using spanners.

About 30 mm

Collet

Y-origin detection pin

Large wrench

(included with the

cutting machine)

Sensor cable

Pass here

Insert

Small wrench

(included with the

cutting machine)