User`s manual

2-3 Setting the Y-axis Origin Point for the Center of Rotation
Chapter 2 Preparation
16
4. Use the operation-panel screen for make the setting for the Y-axis origin point.
➊
Close the front cover.
Press the VIEW button to make the VIEW light go out.
➋
Use the operation panel screen to se-
lect [Set the Y origin at the center of
rotation].
Select [Start Detection].
➌
Click [Continue].
The Y-origin detection pin automatically
makes contact with the sensor.
➍
When the screen appears, open the front cover.
Rotate the spindle half a turn.
➎
Close the front cover.
Click [Continue].
The Y-origin detection pin automatically
makes contact with the sensor, and the Y ori-
gin point for the rotary axis unit is set, again.
Next, the screen shown in the figure appears.
Spindle
Spindle