User`s manual

2-3 Setting the Y-axis Origin Point for the Center of Rotation
Chapter 2 Preparation
17
➏
Open the front cover.
Turn the core-support retaining lever to move the core
support
➐
Detach the sensor cable and the small Y-origin sensor.
5. Install the large Y-origin sensor.
➊
Loosen the adjuster lock.
Turn the core-support adjuster to extend the end about 5
mm.
➋
Install the large Y-origin sensor on the workpiece chuck.
Move the core support, expand the workpiece chuck, then install
the large Y-origin sensor.
Core-support retaining lever
Core support
Core-support
Workpiece chuck
Install with this
orientation.
Install it so that the holes in the
sensor are at the front and back.
1. Loosen
2. Turn
About 5 mm
Adjuster lock
Core-support adjuster
Align the sensor with the notch and
install.