User`s manual

2-3 Setting the Y-axis Origin Point for the Center of Rotation
Chapter 2 Preparation
19
6. Use the operation-panel screen for make the setting for the Y-axis origin point.
➊
Click [Continue].
The Y-origin detection pin automatically makes con-
tact with the sensor.
➋
When the screen appears, open the front cover.
Rotate the spindle half a turn.
➌
Close the front cover.
Click [Continue].
The Y-origin detection pin automatically makes con-
tact with the sensor, and the Y origin point for the ro-
tary axis unit is set, again.
Next, the screen shown in the figure appears.
➍
Open the front cover.
Turn the core-support retaining lever to move the core
support.
Spindle
Spindle
Core-support
Core-support retaining lever