User`s manual

3-2 Loading a Workpiece
Chapter 3 Operation
30
Loading a Workpiece 120 mm or Longer in Length
When you're loading a workpiece measuring 120 mm or longer, follow the steps below.
1. Entering the length of the workpiece at the operation panel screen.
➊
Click [Workpiece Length].
➋
Enter the length of the mounted
workpiece.
Click [OK].
2. Carry out the preparations for securing the workpiece in place.
➊
Close the front cover.
Press the VIEW button to make the VIEW light go out.
➋
Turn the workpiece chuck to a position where the chuck-
tightening knob is facing upward.
➌
Open the front cover.
Mount the center drill on the core support.
Chuck-tightening knob
Center drill
Core support
3. Insert
1. Loosen
About 5 mm
2. Turn the handle to extend
the end about 5 mm.