User`s manual

3-3 Installing a Tool and Setting the Cutting-start Location
Chapter 3 Operation
37
2. Make the setting for Z origin point.
➊
Make sure to insert the sensor cable to Z-origin sensor.
➋
Using the operation panel screen, select
[Set the Z origin at the center of rota-
tion].
Select [Start Detection].
➌
Click [Continue].
The tool automatically makes contact with the
sensor, and the Z-axis origin point is set.
3. Make the setting for A origin point.
➊
Use the operation-panel screen to rotate the workpiece to the cut-
ting-start location.
➋
Select [Set the A origin here].
Click [Set].
The start location in the A origin has now been
set.