User`s manual

Chapter 3 Operation
38
3-4 Changing the Angle of Cutting
➊
If the cutter installed, detach it.
➋
Loosen the screws shown in the figure.
➌
Detach the screw shown in the figure.
➍
Pull the angle-fixing control.
Turn to a position not lined up with the groove.
➎
Turn to align with the scale on the angle-adjust-
ment dial.
Each tick of the scale corresponds to 15 degrees of tilt.
Hexagonal wrench
Scale
Angle-adjustment dial
Angle-fixing control
Groove
Large hexagonal driver
(included with the
cutting machine)