User's Manual

30
Performing
fig.stop-up-ver.eps
1.
From the main screen, press the lower part of a division tablet.
The “Voice Palette” screen will appear, showing the variation of the selected stop.
fig.LCD016.eps
* If the indicator blinks momentarily when you press the tablet, a variation is already selected for the stop.
* If the “Voice Palette” screen is not shown, return to the main screen and perform the procedure from step 1. To return to the main
screen, refer to “Returning to the main screen” (p. 27).
You can also access the “Voice Palette” screen by holding in the [SET] piston and pressing the desired division tablet.
2.
Turn the [Value/Exit Menu] knob.
You can choose from four sound variations: VP0 through VP3.
fig.LCD015.eps
Storing the state in which a variation is selected for the stop
You can do this in either of the following two ways.
Storing the variations that will be selected immediately after power-up
For each stop, select the variation that you want to be available immediately after the power is turned on, and then store the system
settings as described in “Storing Your Settings (Customize)” (p. 73). The state of the voice palette will be reproduced the next time you
turn on the power.
Storing a registration
Select the variation for each stop, and then store your settings as a Registration (p. 47). This allows you to store the state of the
selected variations in a memory piston.
If you selected a [USER MIDI A] or [USER MIDI B] division tablet
The “USER/MIDI” screen will appear, allowing you to select sounds that are not included in the sound tablets (p. 79). For details, refer to
“Settings for the USER/MIDI Couplers” (p. 68).
fig.LCD017.eps
Selecting a Sound Variation (Voice Palette)
Press the lower part of a tablet
C-380_330_e.book 30 ページ ２０１０年４月２８日 水曜日 午後１０時１１分