User Manual

22
Turning the Power On and Off
You can operate the CD-2u/SD-2u either with the dedicated AC adaptor, six alkaline batteries
(AA, LR6, sold separately), or rechargeable Ni-MH batteries (AA, HR6, sold separately).
* Before turning the unit on/off, always be sure to turn the volume down. Even with the volume
turned down, you might hear some sound when switching the unit on/off. However, this is
normal and does not indicate a malfunction.
If you’re using the dedicated AC adaptor, batteries are not required.
* Even if batteries are installed, the unit will turn off if you connect or disconnect the power cord
from the AC outlet while the unit is turned on, or if you connect or disconnect the AC adaptor
from the unit. When this occurs, unsaved data may be lost. You must turn off the power before
you connect or disconnect the power cord or AC adaptor.
1
Connect the power.
* Place the AC adaptor so the side with the indicator (see illustration) faces upwards.
The indicator will light when you plug the AC adaptor into an AC outlet.
fig.ACadaptor-e.esp
2
Press and hold the [POWER] switch.
When the screen appears in the display, release the switch.
fig.power-on.eps0
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning the
unit on is required before it will operate normally.
Using the Dedicated AC Adaptor
To AC
outlet
Dedicated AC Adaptor (included)
Power cord (included)
Bottom
Panel
Cord hook
To prevent the inadvertent disruption of power to your unit (should
the plug be pulled out accidentally), and to avoid applying undue
stress to the DC IN jack, anchor the power cord using the cord hook,
as shown in the illustration.
* Do not force the cord into the slot. Doing so may break it.
* When turning the CD-2u/SD-2u upside down, place stacks of newspapers or magazines to
support the four corners (or two sides) so that stress is not placed on the buttons or knobs,
possibly damaging them.
Indicator
* The shape of the power cord’s plug varies
depending on the country.
Connect the plug of the dedicated AC adaptor to the
AC adaptor jack on the CD-2u/SD-2u’s rear panel.
Connect the included power cord to the dedicated
AC adaptor.
Plug the power cord all the way into the AC outlet.
CD-2u_SD-2u_e.book 22 ページ ２０１３年１月２４日 木曜日 午前１１時３４分