User Manual

Recording Acoustic Instruments or Vocals

(continued)

Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices

Convenient

Functions

Information

/ Display

Checking /

Preparations

Press the [ ] (Record) button to enter recording-standby mode.

fig.rec-intmic04-e.eps

Press the [ ] (Play) button to begin recording.

Start your performance.

fig.rec-intmic05-e.eps

Press the [ ] (Stop) button to stop recording.

fig.rec-intmic06-e.eps

The recorded song will be added to the end of the SD memory card or CD-R/RW disc.

If you want to listen to the song you recorded, press the [ ] (Play) button

immediately after you stop recording.

Blinking

Remote control

Lit

Remote control

●

Depending on where the CD-2u/SD-2u is positioned in relation to the sound source, the

recorded sound may not be evenly distributed between the left and right speakers. In such

cases, you can adjust the left/right volume balance of the internal mics and record your

performance again. For details, refer to “Adjusting the Left/Right Volume Balance of the

Internal Mics” (Page 120).

●

When turning the [MIC] knob, you may hear a faint noise when the input level changes,

but this is not a malfunction.

Important

●

Since the CD-2u is equipped with highly-sensitive mics, undesired sounds such as the

operating noise of the CD-R/RW drive or the sound of buttons being pressed may be

recorded inadvertently. If you notice such problems, you can try lowering the input level

of the internal mics.

If you’re recording to an SD memory card, no CD-R/RW drive operating noise will be

recorded.

●

If you’ve finished recording a CD-R/RW disc and would like to play that disc on another

CD player, you’ll need to execute the “Finalize” operation. You can finalize the CD-R/RW

disc when ejecting it. For details, refer to “Making a CD-R/RW Disc for Playback on

Another CD Player (Finalize)” (Page 99).

Important

CD-2u_SD-2u_e.book 43 ページ２０１３年１月２４日　木曜日　午前１１時３４分