Specifications

18
Shafts Shafts
72 mm or less
Shafts
When using a thick
roll of material
When only a small amount of material
remains (material diameter is 72 mm
(2-7/8 in.) or less)...
Not OK
Loading Roll Material
* When performing lengthy cutting of 1.5 m (60 in.) or more, please refer to the section “4-3 To
Perform Lengthy Cutting”.
For information on how to install the sheet hangers, shafts, brake, and stoppers, please refer to the “ASSEMBLY INSTRUCTIONS”
for the PNS-502/402/302 (the stand for the GX-500/400/300).
1
Mount the shafts on the sheet hangers to match the outer diameter of the roll material. If mounted at an incorrect position,
the roll may fall off.
2
Place the roll material on the shafts.
3
Lower the sheet loading levers to raise the pinch rollers.
Release the brake and pass the end of the material between
the pinch rollers and the grit rollers so that it extends from
the front of the unit.
Performing high-speed cutting when only a little roll material remains may cause the
roll to fall off the shafts. If this happens, it may help to pass the shaft through the roll.
Brake
Sheet hanger
Shafts
Sheet hanger
Stoppers
Sheet Loading Levers