User`s manual

17
9
Close the front cover.
Use the and keys to select [Roll], then press the
ENTER
key.
* If cutting is to be performed from the front edge of the material, select
"EDGE."
Close the front cover
SELECT SHEET
ROLL EDGE PIECE
10
Press the key. The SETUP LED lights up, and the horizontal width of the
material is detected and shown on the display.
* If "EDGE" has been selected for the material, then after the width of the
loaded material is detected, the front edge of the material is aligned with the
cutting-start area.
If a pinch roller is positioned over an area where there is no grit roller, the
message shown at right appears when you press the key.
If this occurs, lower the sheet loading levers and move the pinch rollers to the
proper positions above the grit rollers.
Reposition the material to match this new alignment, then lower the sheet
loading levers to hold the material in place.
Change Pinch
Roller Position
PRESS SETUP KEY
WIDTH LENGTH
28920 ---
11
Press the
MENU
key once to display the top menu.
AREA LENGTH
MOVE < 5.0m>
Use or to change the
value.
Use or to select “MOVE.”
Press
ENTER
.
AREA AXIS
REPLOT SUBMENU
Use or to select.
Press
ENTER
.
Top menu
1 CUT 50cm/s
0.250mm 30gf
Press
MENU
once.
12
(1) Press the
MENU
key on the top menu once.
(2) Use the
and key to move the blinking cursor to [AREA], then press the
ENTER
key.
(3) Move the blinking cursor to the numerical value under [LENGTH]. Use the
and keys to set the required material length for cutting. Set this to a value
that's about 0.1 m longer than the length of the cutting data.
Press
ENTER
key to fix the displayed values.
(4) Use the
and keys to move the blinking cursor to [MOVE], then press the
ENTER
key. The material is fed out by the length set for [LENGTH].
If the material is misaligned and looks like it might come loose from the pinch
rollers, or actually does come loose, please reload the material.