User`s manual
19
7
Use the control panel to make the following setting.
AREA LENGTH
MOVE < 1.0m>
AREA LENGTH
MOVE < 2.0m>
1 CUT 50cm/s
0.250mm 30gf
WIDTH LENGTH
14612 ------
PRESS SETUP KEY
SELECT SHEET
ROLL EDGE PIECE
AREA AXIS
REPLOT SUBMENU
Press .
Press .
Press
Press or to
.
Press .
select [ROLL].
Press .
Press or to
select [AREA].
Press .
Press or to
select [MOVE].
Press or to select the value.
Press or to change the value.
Set this to the
length of the
material to be
cut.
The set length of material is fed out.
Make sure that the material remains held by the pinch rollers.
If the material does come loose from the pinch rollers, set it in place again.
2
Follow steps 4, 5, and 6 of " Loading Roll Material" to load a piece of material.
3
Close the front cover.
Use the and keys to select [PIECE], then press the
ENTER
key.
Close the front cover
SELECT SHEET
ROLL EDGE PIECE
4
Press the key. The tool carriage will move from side to side and the material
will move forward and backward to detect the size of the material.
When sensing ends, the display shows the loaded material size.
If a pinch roller is positioned over an area where there is no grit roller, the
message shown at right appears when you press the
key.
If this occurs, lower the sheet loading levers and move the pinch rollers to the
proper positions above the grit rollers.
Reposition the material to match this new alignment, then lower the sheet
loading levers to hold the material in place.
Change Pinch
Roller Position
WIDTH LENGTH
28920 150
PRESS SETUP KEY
When detecting the material size in step 4, if the material is misaligned and looks like it might come loose from the pinch rollers, or
actually does come loose, please reload the material.
Loading Flat Material (Standard-size Material, Cut Material, Etc.)
1
Lower the sheet loading levers and pass the material
between the pinch rollers and the grit rollers.
Pass the material
• If the material tends to reroll in the direction of its top surface (the cutting surface), roll the material in the other
direction so that its backing paper is bent inward. If you perform cutting without changing the direction of the crease,
the material may rise up during cutting and become caught on the front cover.
• If the material strikes the shaft during cutting, remove the shaft.